Wiring Harness Disassemble

1. Use a small screwdriver in order to disconnect the wiring harness assembly (224) from the electrical connector (35) in the case.





2. Use a small screwdriver in order to disconnect the wiring harness assembly at the following locations:
^ The 1-2 and 3-4 shift solenoid valve (315)
^ The 2-3 shift solenoid valve (315)
^ The Torque Converter Clutch (TCC) PWM solenoid valve (325)
^ The TCC apply solenoid valve (315)
^ The TFT sensor (391) located on the case cover or on the spacer plate
^ The wiring harness clip

3. Remove the wiring harness assembly (224).