Cylinder Head Assemble

^ Tools Required
- J 38606 Valve Spring Compressor





1. Lightly lap the reconditioned valves into the valve seat.

Important: Use oversize valve stem seals if you install oversize valves.

2. Install the valve stem oil seals.
3. Install the valves.
4. Install the valve springs.
5. Install the valve spring caps.





6. Compress the valve springs using the J 38606.
7. Install the valve spring cap keys.
Hold the valves in place with grease, if necessary.
8. Release the valve springs.
9. Ensure that the valve locks are seated.





10. Install the fuel line bracket.

Notice: In order to avoid damage, install the spark plugs after the cylinder head has been installed on the engine.

11. Install the fuel line bracket bolt and stud.
^ Tighten the fuel line bracket bolt and stud to 50 Nm (37 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.