Piston and Connecting Rod Disassemble

^ Tools Required
- J 24086-C Piston Pin Remover/Installer





1. Remove the piston rings from the piston. Use a suitable tool in order to expand the piston rings. Do not reuse the piston rings.

CAUTION: Handle the piston carefully. Worn piston rings are sharp and may cause bodily injury.





2. Select fork insert J 24086-310. Install the fork upside down into the press.

Important: Do not put any load on the piston during disassembly.

3. Place the piston and connecting rod assembly into the J 24086-C and press out the piston pin. Ensure that the connecting rod is above the fork when installing the piston and connecting rod assembly into the press.
4. Mark the piston pin to the piston from which the pin was removed.