Camshaft Position Sensor: Service and Repair

Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in Service Precautions.
2. Remove the serpentine drive belt.
3. Refer to Steering and Suspension for removal of power steering pump assembly.
4. Remove the electrical connector.
5. Remove the bolt.
6. Remove the sensor.

Installation Procedure
1. Install the camshaft Position Sensor.
Tighten
Tighten the retaining bolt to 10 Nm (8 lb ft).
Refer to Fastener Notice in Service Precautions.
2. Install the electrical connector.
3. Install the power steering pump.
4. Install the serpentine drive belt.