Upper Tilt Head Components

This article includes procedures for the following components:
- Upper Tilt Head Components
- Shaft Lock Shield ASM
- Turn Signal Cancel Cam ASM
- Upper Bearing Spring
- Upper Bearing Inner Race

Tilt Steering Column - Part 1 Of 2:

Tilt Steering Column - Legend - Part 2 Of 2:

^ Tools Required:
- J 23653-SIR Lock Plate Compressor

REMOVE OR DISCONNECT
1. Do steps 1 through 5 under REMOVE OR DISCONNECT, in SIR COIL ASSEMBLY.
^ Let SIR coil assembly (2) hang freely.

Removing Shaft Lock Bearing Retainer:

2. Shaft lock bearing retainer (4) using J 23653-SIR to push down shaft lock shield assembly (5).
^ Dispose of bearing retainer(4).

Removing Upper Shaft Components:

3. Shaft lock shield assembly (5).
4. Turn signal cancel cam assembly (6).
5. Upper bearing spring (7).
6. Upper bearing inner race seat (8).
7. Inner race (9).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Inner race (9).
2. Upper bearing inner race seat (8).
3. Upper bearing spring (7).
4. Turn signal cancel cam assembly (6).
5. Shaft lock shield assembly (5).
^ Align inner block tooth of lock plate to block tooth of race & upper shaft assembly (34).
^ Lubricate with grease, synthetic (service kit).
6. New shaft lock bearing retainer (4) using J 23653 SIR to push down shaft lock shield assembly (5).
^ Bearing retainer (4) must be firmly seated in groove on shaft.
7. Do steps 1 through 4 and 6 through 10 under INSTALL OR CONNECT, in SIR COIL ASSEMBLY.