Operation CHARM: Car repair manuals for everyone.
Home >> Buick >> 1998 >> Regal V6-3100 3.1L VIN M SFI >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Shift Linkage >> Shift Cable >> Service and Repair >> 4T60-E Automatic Transaxle >> A/T Range Selector Cable Replacement (at PNP Switch)

A/T Range Selector Cable Replacement (at PNP Switch)

REMOVAL PROCEDURE

CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.





1. Remove the throttle body air inlet duct. Refer to Throttle Body Assembly Replacement in Powertrain Management.
2. Remove the automatic transaxle range selector cable from the wiring harness clip or strap.
3. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.





4. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
5. Remove the automatic transaxle range selector cable from the console shift control or the column shift control. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only) or Automatic Transmission Range Selector Cable Replacement (At Column Shift Control).
6. Pull the automatic transaxle range selector cable through the dash from the engine compartment side.

INSTALLATION PROCEDURE

CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.





1. Insert the automatic transaxle range selector cable through the dash from the engine compartment side.
2. Install the automatic transaxle range selector cable to the automatic transaxle range selector cable bracket.





3. Install the automatic transaxle range selector cable to the automatic transaxle range selector lever.
4. Install the automatic transaxle range selector cable to the wiring harness clip or strap.
5. Install the automatic transaxle range selector cable to the console shift control or the column shift control. Refer to Automatic Transmission Range Selector Cable Replacement (At Column Shift Control) or Automatic Transmission Range Selector Cable Replacement (At Console Shift Control).
6. Adjust the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only) and/or Automatic Transmission Range Selector Cable Adjustment.
7. Install the throttle body air inlet duct. Refer to Throttle Body Assembly Replacement in Powertrain Management.

pro multis · About Operation CHARM