P0719

Wiring Diagram:

CIRCUIT DESCRIPTION

The brake switch reports brake pedal status to the Powertrain Control Module (PCM). The brake switch indicates that the brake pedal is either applied or released. The normally-closed switch supplies battery voltage on circuit 420 to the PCM. Applying the brake pedal opens the brake switch, interrupting voltage to the PCM. When the PCM receives 0 volts at the brake switch input, the PCM turns OFF the Torque Converter Clutch (TCC) Solenoid Valve.

If the PCM detects an open brake switch (pedal applied) during acceleration, then DTC P0719 sets. DTC P0719 is a type D DTC.


CONDITIONS FOR SETTING THE DTC

^ No VSS DTCs P0502 or P0503.

^ The vehicle speed is less than 8 km/h (5 mph);

^ Then the vehicle speed is between 8 km/h (5 mph) and 32 km/h (20 mph) for at least 4 seconds;

^ Finally, the vehicle speed remains above 32 km/h (20 mph) for 5 seconds.

^ The above conditions must occur 7 times with the brake switch ON for more than 15 minutes, and the PCM receiving no voltage input for 2 seconds.


ACTION TAKEN WHEN THE DTC SETS

^ The PCM does not illuminate the Malfunction Indicator Lamp (MIL).

^ Disregard the brake switch for TCC scheduling when all of the following conditions are met:

- The throttle position is greater than 6%.

- The vehicle speed is greater than 70 km/h (44 mph).

- The throttle position was previously greater than 12% while the vehicle speed was greater than 75 km/h (47 mph).

- The brake switch has not been OFF for more than 2 seconds this ignition cycle.


CONDITIONS FOR CLEARING THE DTC

^ A scan tool can clear the DTC from the PCM history. The PCM clears the DTC from the PCM history if the vehicle completes 40 warm-up cycles without a failure reported.

^ The PCM cancels the DTC default actions when the fault no longer exists and the ignition is OFF long enough in order to power down the PCM.


DIAGNOSTIC AIDS

^ Inspect the wiring at the PCM, the brake switch connector and all other circuit connecting points for the following conditions:

- A bent terminal

- A backed out terminal

- A damaged terminal

- Poor terminal tension

- A chafed wire

- A broken wire inside the insulation

- Moisture Intrusion

- Corrosion

^ When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change.

TEST DESCRIPTION

The numbers below refer to the step numbers on the Diagnostic Table.

5. This step isolates the fault between the TCC Brake Switch and the harness.