Power Antenna Assembly Replacement

Power Antenna Mounting:

REMOVE OR DISCONNECT
1. Pull back rear compartment trim.
2. Antenna mast.
3. Drain hose from drain hole.
4. Relay connector.
5. Coaxial lead.
6. Antenna ground lead bolt.
7. Antenna bracket bolt.
8. Antenna assembly.
9. Bezel from quarter panel.

INSTALL OR CONNECT
^ Apply lubricant to bezel.
1. Bezel into quarter panel.

Tighten
^ Bezel nut to 4 N.m (35 lb in).

2. Antenna assembly.
3. Antenna bracket bolt.

Tighten
^ Bolt to 7.5 N.m (66 lb in).

4. Antenna ground lead bolt.

Tighten
^ Bolt to 7.5 N.m (66 lb in).

5. Coaxial lead.
6. Relay connector.
7. Drain hose through drain hole.
8. Antenna mast.
9. Rear compartment trim.