Training UGDO For Rolling Code Receivers

1. Program your hand-held transmitter to the UGDO transmitter as described in Universal Garage Door Opener Programming Procedure. Universal Garage Door Opener Programming Procedure
2. Remove the cover from your garage door opener receiver. (The receiver should be located by the garage door opener motor).
3. Locate the training button on the garage door opener receiver. (Reference the operators manual for the garage door opener, or call 1-800-355-3515 for assistance).
4. Press the training button on the garage door opener receiver for 1-2 seconds.
5. Return to the UGDO transmitter in the vehicle and depress the button that you want programmed for the duration of the rapid flash of the UGDO red light, (1-2 seconds).
6. Release the button and re-press to verify that the UGDO transmitter has been programmed.