Forward Body Mount Replacement

REMOVAL PROCEDURE






1. Raise the vehicle.
2. Remove the wheels and the tires.
3. Remove the exhaust system. Refer to EXHAUST SYSTEM in ENGINE.
4. Use a jack stand in order to support the forward end of the rear suspension support assembly.
5. Remove the brackets from the body at the support assembly forward mounts.
6. Remove the two bolts that secure the front of the support assembly to the body of the vehicle.
7. Lower the front. end of the support assembly in order to enable mount removal.
8. Use a punch in order to perform the following actions.
8.1. Bend the tabs on the inboard mount (2)
8.2. Tap the mount (1) downward and out of the support assembly.

INSTALLATION PROCEDURE





1. Tap the mount into the support assembly, ensuring the following conditions upon installation:
^ The flat is outboard (2).
^ The notch is rearward (1)
2. Use a large pair of channel lock pliers in order to bend the tabs (2) outboard.
3. Raise the support assembly to the body of the vehicle.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Install the two bolts that secure the front of the support assembly to the vehicle body.

Tighten
Tighten the bolts to 191 Nm (141 ft. lbs.).
5. Install the brackets to the body at the support assembly forward mounts.

Tighten
Tighten the bolts to 86 Nm (63 ft. lbs.).

6. Install the exhaust system. Refer to EXHAUST SYSTEM in ENGINE.
7. Install the wheels and the tires.

Tighten
Tighten the wheel nuts to 140 Nm (100 ft. lbs.).

8. Lower the vehicle.