HVAC Programmer

Heater And A/C Programmer:

Remove or Disconnect

1. Negative battery cable.
2. Right sound insulator.
3. Glove box.
4. Electrical connectors from programmer.
5. Retaining tabs from programmer.
6. Programmer.

Install or Connect

1. Programmer into retainer on bracket.
2. Electrical connectors to programmer.
3. Glove Box.
4. Right sound insulator.
5. Negative battery cable.

Important
^ After the programmer has been replaced, the actuators need to be recalibrated for proper travel. The ignition must be cycled ON for 3 minutes to allow the programmer and the actuators to recalibrate for proper travel.