Operation CHARM: Car repair manuals for everyone.

Crankshaft Position Sensor Replacement




Crankshaft Position Sensor:






Removal Procedure

Tools Required

^ J 36660 Torque/Angle Meter.
^ J 37096 Flywheel Holding Tool.
^ J 38197 Balancer Remover.

1. Disconnect the negative battery cable.
2. Remove the serpentine belt(s) from the crankshaft pulley.
3. Raise the vehicle on a hoist.
4. Remove the right front wheel and tire assembly.
5. Remove the right inner fender access cover.
6. Hold the flywheel with J 37096 Flywheel Holding Tool.
7. Using 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
8. Remove the crankshaft harmonic balancer using special tool J 38197 Balancer Remover.
9. Remove the crankshaft position sensor shield (1). Do Not use a pry bar.
10. Disconnect the sensor electrical connector.
11. Remove 2 attaching bolts from the crankshaft position sensor.
12. Remove the crankshaft position sensor from block face.

Installation Procedure
1. Position the crankshaft position (CKP) sensor to the block.
2. Install the bolts to hold the CKP sensor to the block face.

Tighten to 20-40 Nm (14-28 lb ft).

3. Install the crankshaft position sensor shield.
4. Connect the CKP sensor electrical connector
5. Position the crankshaft harmonic balancer on the crankshaft.
6. Hold the flywheel with J 37096 Flywheel Holding Tool.

Tighten, using J 36660 Torque/Angle Meter, the harmonic balancer bolt to 150 Nm +76 degrees (110 lb ft +76 degrees).

7. Install the right inner fender access cover.
8. Install the right front wheel and tire assembly.

Tighten to 140 Nm (104 lb ft).

9. Lower the vehicle.
10. Install the serpentine belt(s).
11. Connect the negative battery cable.
12. Perform the Crankshaft Position System Variation Learn Procedure.