Upper Control Valve Body Assemble

1. Inspect all valve body passages for debris, and then inspect the gasket for damage.





2. Install the automatic transmission fluid temperature sensor.
^ Tighten the automatic transmission fluid temperature sensor to 3.4 Nm (30 inch lbs.).





3. Install the following parts:
^ The 1-2, 3-4 accumulator valves (301, 302)
^ The bushing (303)
^ The coiled spring pin (304)





4. Install the following parts:
^ The 2-3 accumulator valve (306)
^ The bore plug (307)
^ The retainer clip (308)





5. Install the following parts:
^ The actuator feed limit valve (309)
^ The actuator feed limit valve spring (310)
^ The spring retaining plate (311)





6. Install the following parts:
^ The converter feed limit valve (312)
^ The converter feed limit valve spring (313)
^ The bore plug (307)
^ The retaining clip (308)





7. Install the following parts:
^ The torque converter clutch enable valve (322)
^ The torque converter clutch enable valve spring (323)
^ The bore plug (307)
^ The retainer clip (308)





8. Install the following parts:
^ The converter regulator valve (318)
^ The converter regulator valve spring (319)
^ The bore plug (307)
^ The retainer clip (308)





9. Install the following parts:
^ The converter clutch control spring (316)
^ The converter clutch control valve (317)
^ The coiled spring pin (304)
^ The torque converter clutch solenoid valve (336)
^ The spring retainer clip from the torque converter clutch solenoid valve (337)





10. Install the following parts:
^ The pressure control solenoid filter and seal (338)
^ The pressure control solenoid valve (339)
^ The pressure control solenoid clamp (340)

11. Install the clamp bolt (15).
^ Tighten the bolt to 11-13 Nm (8.0-9.5 ft. lbs.).





12. Install the following parts:
^ The 2-3 accumulator pin (348)
^ The snap ring (349)
^ The 2-3 accumulator piston spring (347)
^ The accumulator piston and seal (345, 346)
^ The 2-3 piston cushion spring (351)