Remote Function Actuator (RFA) Module

The RFA module is located in rear compartment underneath right side of package shelf.

Important: When the RFA module is being replaced it is very important to follow installation procedure carefully. Failure to do so will cause inoperative or malfunctions in the RFA system.

Remove or Disconnect

1. Open rear storage compartment.
2. Electrical connector from RFA module.
3. Slide RFA module from bracket.

Install or Connect

1. Slide RFA module onto bracket.
2. Electrical connector.
3. Program transmitters, refer to Programming Transmitters. Transmitter Programming
4. Connect scan tool.
5. Turn ignition to ON.
6. Select vehicle being programmed.
7. Select Body.
8. Select RFA.
9. Select RFA Test.
10. Select Set Options.
11. Select Options 0.

^ Follow screen prompts and instructions.

12. Scroll through screens until desired function is displayed, select Yes on each function that needs to be enabled for the particular vehicle being serviced.

^ Use RFA function chart in this section and select the functions that are standard or optional for the particular vehicle being serviced. Failure to program the RFA module properly will cause the system to malfunction causing misdiagnosis and customer complaints.
^ When selecting functions on a new RFA module on a vehicle that has Theft Deterrent (UA6), you must go into Option 3 on scan tool. FACTORY USE ONLY SPEED UP will appear as your only selection, select NO, then EXIT the system. If this function is not reset, the 30 second theft lamp illumination will be reduced to 2 seconds. Misdiagnosis of the Theft Deterrent system may occur if this function is not set properly.

13. Exit system.
14. Disconnect scan tool.