Crankshaft, Engine

Main Bearing Journal Diameter 60.00 - 60.024 mm (2.3622 - 2.3631 inch)
Width, Main Thrust Bearing Journal No. 3, Including Fillets 27.837 - 27.913 mm (1.0959 - 1.0989 inch)
Out Of Round Maximum 0.005 mm (0.0002 inch)
Straightness, Taper 0.007 mm (0.0003 inch)
Crankshaft Bearing Clearance 0.010 - 0.060 mm (0.00039 - 0.0023 inch)
Rod Bearing Journal Diameter 47.975 - 48.00 mm (1.8898 - 1.8914 inch)
Rod Bearing Inside Diameter 48.001 - 48.043 mm (1.8898 - 1.8914 inch)
Out Of Round 0.005 mm (0.0002 inch)
Straightness, Taper 0.007 mm (0.0003 inch)
Connecting Rod Bearing Clearance 0.010 - 0.068 mm (0.00039 - 0.0026 inch)
Rod Side Clearance 0.150 - 0.450 mm (0.0059 - 0.0177 inch)
Connecting Rod Journal Width 23.370 - 23.750 mm (0.9200 - 0.9350 inch)
Runout Of Crankshaft At The Flywheel Flange Maximum 0.050 mm (0.002 inch)
Runout Of Crankshaft Maximum 0.050 mm (0.002 inch)
Supported On Front And Rear Journals Clearance To The Crankshaft Position Sensor 0.77 - 1.77 mm (0.0303 - 0.0697 inch)
Flywheel Fit 0.000 - 0.013 mm loose (0.0000 - 0.0005 inch)
Flange Runout Maximum 0.03 mm (0.00120 inch)
Stroke Of Crank 94 mm (3.70 inch)
ID Of Seal Diameter On Crank 81.96 - 82.04 mm (3.2210 - 3.2299 inch)
Runout Of Seal Surface 0.05 mm max (0.002 inch)
Balancer Hub ID To Crank Snout OD 33.00 - 33.03 mm (1.2992 - 1.3004 inch)
ID Balancer 33.000 - 33.03 (1.2992 - 1.3004 inch)
Timing Gear Fit To Crankshaft Snout 33.03 - 33.06 mm (1.3004 - 1.3016 inch)