Ignition Lock Actuator & Lock Bolt Assemblies

Standard Steering Column (Part 1 Of 2):

Standard Steering Column - Legend (Part 2 Of 2):

REMOVE OR DISCONNECT
1. Steering column lock cylinder set.

Removing Lock Bolt:

C. Ground strap (15) from lock pre-load spring (14).
D. Lock pre-load spring (14).
2. Ignition lock actuator assembly (12) from steering column housing assembly (11) with needle nose pliers.
3. Lock bolt assembly (21).
A. Do steps 1 through 3. Refer to UPPER BEARING & HOUSING COMPONENTS.
B. Two tapping screws (23).
C. Lock bolt support bracket (22).
D. Lock bolt asm (21) and lock bolt spring (16) from housing assembly(11).

INSTALL OR CONNECT

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and system.

1. Lock bolt assembly (21) and upper steering column housing components to steering column housing assembly (11).
A. Lock bolt spring (16).
B. Lock bolt assembly (21).
C. Lock bolt support bracket (22).
D. Two tapping screws (23).
^ Seat upper tapping screw (23) first and lower screw (23) second.
^ Tighten two screws (23) to 3.4 Nm (30 lb in).
E. Do steps 4 through 6. Refer to UPPER STEERING COLUMN HOUSING COMPONENTS.
2. Ignition lock actuator assembly (12) to housing assembly (11).
A. End of lock bolt asm(21) flush with support bracket (22).
B. Ignition lock actuator assembly (12) to housing assembly (11).
C. Rotate actuator (12) counterclockwise until it pushes out lock bolt asm (21) and actuator (12) seats into housing assembly (11).
D. Rotate actuator (12) clockwise to "RUN" position.
3. Lock pre-load spring (14) to housing assembly (11).
4. Ground strap (15) to preload spring.
5. Steering column lock cylinder set.