Ignition Switch

Tilt Steering Column (Part 1 Of 2):

Tilt Steering Column - Legend (Part 2 Of 2):

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Disable the SIR system.

Removing Ignition Switch:

3. Vehicle wire harness from ignition switch assembly (19).
4. Two tapping screws (20).
5. Ignition switch assembly (19).

INSTALL OR CONNECT

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and system.

1. Ignition switch assembly (19).
2. Two tapping screws (20).
^ Tighten screws (20) to 1.7 Nm (15 lb in).
3. Vehicle wire harness to switch assembly (19).
4. If all service operations are completed, enable the SIR system.
5. Negative (-) battery cable.