Cruise Control Module: Service and Repair

The cruise control module assembly is mounted on the "Front Of Dash" (FOD). The module assembly has an electronic controller and an electric stepper motor to vary the throttle with each different cruise control mode. The module assembly is not serviceable.

Cruise Control Module To Bracket:

Cruise Control Module Mounting:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Cruise control cable from module assembly. Refer to Cruise Control Cable. Service and Repair
3. Electrical connector from module assembly.
4. One nut from mounting stud and two screws.
5. Module assembly from front of dash.
6. Module assembly from mounting bracket.

INSTALL OR CONNECT
1. Module assembly to mounting bracket.

IMPORTANT
^ Do not pre-tap screws to module without mounting bracket in between the module and the screw. The added length of the screw may damage the cruise control module.

Tighten
^ Nuts to 10 N.m (89 lb. in.).

2. Module assembly to front of dash.
3. One nut and two screws.

Tighten
^ Nuts to 10 N.m (89 lb. in.).

4. Electrical connector to module.
5. Cruise control cable to module assembly.
6. Adjust cruise control cable. Refer to Cruise Control Cable.
7. Negative battery cable.