B1015
DTC B1015 VIN Information Error:
CIRCUIT DESCRIPTION
The BCM learns the Buick model that it is installed in by using the Vehicle ID Information (VIN) via the class 2 serial data line. Each time the vehicle is in the RUN position or the PCM communicates this information via Class 2, the BCM internally compares the VIN information with that information stored in digits 2 through 5 of the VIN. If digit 5 of the VIN is incorrect, the BCM will indicate a VIN information error is present.
CONDITIONS FOR SETTING THE DTC
^ The BCM detects digit 5 of the VIN is incorrect.
^ The condition must occur when the ignition switch is first turned on.
ACTION TAKEN WHEN THE DTC SETS
The BCM stores DTC B1015 in memory.
CONDITIONS FOR CLEARING THE DTC
^ The BCM recognizes digit 5 of the VIN as valid information.
^ A history DTC will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.
^ Using a scan tool.
DIAGNOSTIC AIDS
DTC B1015 is related to an internal VIN error in the BCM. The VIN information is not removable from the BCM; therefore, try reentering the VIN information and if it is still incorrect, replace the BCM. A service replacement BCM must be programed and configured to the vehicle. Use the scan tool in order to make sure the BCM is properly programmed and configured to the vehicle. Use the scan tool in order to make sure the BCM is properly programmed and configured for the correct Passlock and vehicle option content. Refer to BCM Programming/RPO Configuration for more information. Service and Repair
TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step determines whether the condition is intermittent or the BCM is faulty.