P0121

Circuit Description

The Throttle Position (TP) sensor circuit provides a voltage signal that changes relative to throttle blade angle. The signal voltage will vary from below 1.0 volt at closed throttle to above 4.0 volts at Wide Open Throttle (WOT).

When the MAP reading is below 50 kPa the diagnostic checks for a skewed high TP Sensor. When the MAP reading is above 70 kPa the diagnostic checks for a skewed low TP Sensor. If the PCM detects an out of range condition, DTC P0121 will be set. The diagnostic will not run between 50 kPa and 70 kPa.

Conditions for Running the DTC

^ No active TP, MAP sensor DTC.
^ The engine is running.
^ The ECT Sensor temperature above 70°C (158°F).
^ The MAP reading is below 50 kPa.
^ The MAP reading is above 70 kPa.
^ The MAP steady for 5 seconds or more.

Conditions for Setting the DTC

^ The TP Sensor reading is above the predicted value when the MAP is below 50 kPa.
^ The TP Sensor reading is below the predicted value when the MAP is above 70 kPa.
^ Above conditions are present for 10 seconds.

Action Taken When the DTC Sets

^ The PCM will illuminate the MIL during the second consecutive trip in which the diagnostic has been run and failed.
^ If equipped with traction control, the PCM will command the Electronic Brake and Traction Control Module (EBTCM) via the serial data circuit to turn OFF traction control, and the EBTCM will illuminate the TRACTION OFF lamp.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame and Fail Records data.

Conditions for Clearing the MIL/DTC

^ The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.
^ The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

Diagnostic Aids

Check for the following conditions:

Skewed MAP signal or faulty MAP sensor. A skewed MAP signal may cause the PCM to incorrectly determine the TP Sensor is out of range. Check for an unusually low or high MAP reading. This condition can cause DTC P0121 to be set.

Important: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Poor terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Use a corresponding mating terminal to test for proper tension. Refer to Diagrams.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness appears to be OK, observe the sensor display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the sensor display may indicate the location of the fault.
^ Inspect the PCM and the engine grounds for clean and secure connections.

If the DTC is determined to be intermittent, reviewing the Fail Records can be useful in determining when the DTC was last set.

Test Description

The numbers below refer to the step numbers on the Diagnostic Table:

2. An incorrect MAP signal may cause the PCM to incorrectly calculate the predicted TP sensor value during high engine load situations. Test for an unusually low MAP reading. This condition can cause DTC P0121 to be set.
12. This vehicle is equipped with a PCM which utilizes an Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is being replaced, the new PCM must be programmed.