Operation CHARM: Car repair manuals for everyone.

P0443









Circuit Description

Output Driver Modules (ODMs) are used by the PCM to turn on many of the current-driven devices that are needed to control various engine and Transaxle functions. Each ODM is capable of controlling up to 7 separate outputs by applying ground to the device which the PCM is commanding ON. DTC P0443 set indicates an improper voltage level has been detected on the output circuit which controls the EVAP purge solenoid.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

^ An improper voltage level has been detected on the output circuit which controls the EVAP canister purge valve.
^ The above conditions are present for at least 30 seconds.

Action Taken When the DTC Sets

^ The PCM will illuminate the MIL during the second consecutive trip in which the diagnostic test has been run and failed.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame and Fail Records data.

Conditions for Clearing the MIL/DTC

^ The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.
^ The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using the scan tool Clear Info function or by disconnecting the PCM battery feed.

Diagnostic Aids

Check for the following conditions:

^ Poor connection at the PCM.
Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection.
^ Damaged harness.
^ Inspect the wiring harness for damage. If the harness appears to be OK, disconnect the PCM, turn the ignition ON and observe a voltmeter connected between the EVAP canister purge valve control circuit and ground at the PCM harness connector while moving connectors and wiring harnesses related to the EVAP canister purge valve. A change in voltage will indicate the location of the malfunction.

Reviewing the Fail Records vehicle mileage since the diagnostic test last failed may help determine how often the condition that caused the DTC to be set occurs. This may assist in diagnosing the condition.

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

1. The Diagnostic System Check prompts you to complete some basic checks and store the freeze frame and failure records data on the scan tool.
2. Listen for an audible clicking when the Purge solenoid operates. Command both the Increase and Decrease states. Repeat the commands as necessary.
3. Tests for voltage at the feed side of the solenoid.
4. Verifies that the PCM is providing ground to the solenoid.
5. Tests if ground is constantly being applied to the solenoid.
12. The PCM utilizes Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is replaced, the new PCM must be programmed.