Crankshaft Position (CKP) Sensor Replacement (24X)

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the serpentine drive belt from crankshaft pulley.
3. Raise the vehicle. Refer to Vehicle Lifting in Service Precautions.
4. Remove the crankshaft harmonic balancer retaining bolt.
5. Remove the crankshaft harmonic balancer.
6. Note the routing of sensor harness before removal.
7. Remove the harness retaining clip (3) with bolt (4).
8. Disconnect the sensor electrical connector.
9. Remove the sensor bolts (2).
10. Remove the sensor.

INSTALLATION PROCEDURE
1. Install the 24X Crankshaft Position Sensor with bolts (2) and route harness as noted during removal.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the harness retaining clip with bolt (1).

Tighten
Tighten the bolts to 10 N.m (8 lb ft).

3. Connect the sensor electrical connector.
4. Reinstall the balancer on the crankshaft.
5. Lower vehicle.
6. Reinstall the serpentine drive belt.