Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Disconnect the accelerator cable cross slug from throttle body slot.
2. Depress the tangs and remove the accelerator cable from accelerator cable bracket.




3. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
4. Remove the accelerator cable bracket.

INSTALLATION PROCEDURE




1. Install the accelerator cable bracket to throttle body.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the nuts and bolts. Tighten
^ Tighten the nuts to 26 N.m (19 lb ft).
^ Tighten the bolts to 12 N.m (106 lb in).




3. Connect the accelerator cable into accelerator cable bracket.
4. Connect the accelerator cable cross slug into throttle body slots.