Camshaft Position Sensor: Service and Repair

Locations View:

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the serpentine drive belt.
3. Disconnect the sensor electrical connector.
4. Remove the attaching bolt.
5. Remove the sensor.
6. Inspect the sensor for wear, cracks or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil and replace if damaged.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the camshaft Position Sensor.

Tighten
Tighten the retaining bolt to 10 N.m (8 lb ft).

3. Connect the sensor electrical connector.
4. Reinstall the serpentine drive belt.