Oil Pressure Sensor: Service and Repair

Removal Procedure





1. Disconnect the battery ground (negative) battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Service Precautions.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the electrical connector from the engine oil pressure switch.
4. Remove the engine oil pressure switch.

Installation Procedure





1. Refer to Fastener Notice in Service Precautions. Install the engine oil pressure switch.
Tighten the engine oil pressure switch to 16 Nm (12 ft. lbs.).
2. Connect the electrical connector to the engine oil pressure switch.
3. Lower the vehicle.
4. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Service Precautions.