Power Window Switch Replacement

The content of this article/image reflects the changes identified in TSB

Bulletin No.: 06-08-64-005

Date: January 31, 2006

SERVICE MANUAL UPDATE

Subject:
Revised Power Window Switch Replacement

Models:
1998-1999 Buick Century, Regal





CAUTION: Disconnect the power window switch when working inside the drivers door. When operated, the Express Down feature allows the door window to drop very quickly, which could cause personal injury.

IMPORTANT: When removing a door trim panel or switch plate the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch it a flat-bladed tool awl or metal object is used to remove the switch from the harness.

IMPORTANT: Use protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur.

1. When removing a power window switch (front or rear door), insert a plastic, flat-bladed tool at the front edge of the switch mounting plate. Press rearward to release the mounting plate retainer and lift up on the front of the plate.




3. Unsnap the switches from the mounting plate.

Installation Procedure




1. Install the switches to the mounting plate.




2. Connect the electrical connectors.
3. Snap the switch and mounting plate into the trim panel.