B2241

Outside Mirror Schematics: Left Outside Power Mirror:

DTC B2241 Memory 2 Switch Failed:

CIRCUIT DESCRIPTION
The LH front power window switch receives inputs from the memory function switch. When you press the MEMORY-2 switch, the LH front power window switch recognizes the input and sends a message on the Simple Bus Interface (SBI) to the Driver Door Module (DDM).

The message indicates that the LH front power window switch received a memory recall input. The DDM then relays the message through the class 2 serial data line to the Memory Seat Module (MSM).

CONDITIONS FOR SETTING THE DTC
^ DTC DDM B2241 sets when the MEMORY-2 switch is active for 30 seconds continuously.
^ DTCs B1982 (Battery Voltage High) and B1983 (Battery Voltage Low) must not be current or the diagnostic will not run.

ACTION TAKEN WHEN THE DTC SETS
^ The DDM will not respond to inputs from the shorted memory function switch.
^ The DDM will continue to respond to valid inputs from the other memory function switches.

CONDITIONS FOR CLEARING THE DTC
^ This DTC will set from current to history when the MEMORY-2 switch input cycles off or when the power mode changes from OFF to RUN.
^ The history DTC will clear after 50 ignition cycles.
^ Use a scan tool in order to clear a history DTC.

DIAGNOSTIC AIDS
A history DTC is evidence of an intermittent condition.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step determines if there is a stuck switch or the wiring input to the LH front power window switch. The DTC will set again if there is a short in the wiring or there is an internal LH front power window switch condition. The DTC will not set again if there is a stuck switch because the switch is disconnected from the LH front power window switch.
3. This step determines if there is a short in the input wiring to the LH front power window switch.