Diagnostic System Check - Theft Deterrent

A Diagnostic System Check - Theft Deterrent:

CIRCUIT DESCRIPTION
The Theft Deterrent Diagnostic System Check is an organized approach to identify problems associated with the PASS-Key� III system. This check is the starting point for all PASS-Key� III system complaints, and directs you to the next logical step in diagnosing the complaint. Most system complaints are linked to faulty wiring and connectors, and occasionally to components. Understanding the system and using the diagnostic correctly reduces diagnostic time and prevents unnecessary parts replacement.

DIAGNOSTIC AIDS
The following conditions may result in an intermittent operation of the module with no DTC stored:
- Any condition which results in the interruption of power to the module.
- Out of range battery or ignition voltage.

Specification
Normal module operating voltage: 9.0-16.0 V.

- A loose or damaged ground(s).
- An open or shorted class 2 serial data line. If the DTC is a history DTC the problem may be an electrical intermittent or poor connection. Clear all the DTC's and perform the tests shown while moving related wiring and connectors. This can often cause the malfunction to occur and set a DTC. Perform a thorough inspection of all related wiring and connectors pertaining to the history DTC stored. Refer to Intermittents and Poor Connections Diagnosis in Wiring Systems. Diagnostic Aids
^ Refer to Using Connector Test Adapters in wiring Systems whenever a diagnostic procedure request probing or checking a terminal. Using this adapter ensures that no damage to the terminal occurs and gives an idea of whether contact tension is sufficient. Diagnostic Aids
^ Exit all scan tool tests before cycling the ignition OFF to ON unless the scan tool instructions direct otherwise. Follow the operating instructions in the scan tool operator's manual. Failure to follow these instructions may set DTC's, cause vehicle malfunctions, set false DTCs or cause scan tool malfunctions.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table:
1. This test step determines if communication can be established with the module.
2. This step test for stored module DTCs.
3. This test step determines whether communication can be established with other modules connected to the class 2 serial data line.
4. This step test for any open module power fuses.
5. This step test the module power circuit.
6. This step test the module ground circuit.