Training GDO for Rolling Code Procedure

1. Program your hard-held transmitter to the GDO transmitter as described in Programming Procedure Without Rolling Code Receiver.
2. Remove the cover from your garage door opener receiver.
3. Locate the training button on the garage door opener receiver. Refer to the Operators Manual for the garage door opener, or call 1-800-355-3515 for assistance.
4. Press the training button the garage door opener receiver for 1 - 2 seconds.
5. Return to the GDO transmitter in the vehicle.
6. Depress the button that you want programmed for the duration of the rapid flash of the GDO red light for 1 - 2 seconds.
7. Release the button. Re-press the button in order to verify that the GDO transmitter has been programmed.