Instrument Panel (IP) - End Bracket Replacement - Right

REMOVAL PROCEDURE
1. Remove the IP assembly.
2. Remove the fasteners (2) from the right IP end bracket (1) to the A-pillar.
3. Remove the right IP end bracket (1).

INSTALLATION PROCEDURE
1. Install the right IP end bracket (1) to the A-pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the fasteners (2) to the right IP end bracket (1).

Tighten
Tighten the fasteners to 55 N.m (41 lb ft).

3. Install the IP assembly.