Instrument Panel (IP) - Trim Panel Replacement - Lower

REMOVAL PROCEDURE



1. Remove the right sound insulator.
2. Remove the left sound insulator.
3. Remove the IP cluster trim plate.
4. Remove the right IP vent trim plate.
5. Remove the fastener (2) from the upper edge of the left lower IP assembly.




6. Remove the fastener (1) from the upper edge of the right lower IP assembly.
7. Remove the fasteners (2) from the lower edge of the right lower IP assembly.




8. Remove the fasteners (1) from the lower edge of the left side lower IP assembly.
9. Remove the fasteners (2) from the upper edge of the left lower IP assembly.




10. Remove the fasteners (1) from the upper edge of the right side lower IP assembly.
11. Disconnect the electrical connections on the right side of the vehicle.
12. Remove the lower IP from the vehicle.

INSTALLATION PROCEDURE



1. Connect the electrical connections to the lower IP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the fasteners (1) onto the upper edge of the right side lower IP assembly.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).




3. Install the fasteners (1) on to the lower edge of the left side lower IP assembly.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).

4. Install the fasteners (2) on to the upper edge of the left lower IP assembly.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).




5. Install the fastener (1) on to the upper edge of the right lower IP assembly.

Tighten
Tighten the fastener to 2 N.m (18 lb in).

6. Install the fasteners (2) on to the lower edge of the right lower IP assembly.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).




7. Install the fastener (2) on to the upper edge of the left lower IP assembly.

Tighten
Tighten the fastener to 2 N.m (18 lb in).

8. Install the right IP vent trim plate.
9. Install the IP cluster trim plate.

10. Install the left sound insulator.
11. Install the right sound insulator.