Door Control Module Replacement - Rear

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the rear seat cushion.
3. Disconnect the electrical connectors to the rear door module (1).
4. Remove the fasteners retaining the junction block to the rear floor.

Set junction block aside.
5. Remove the fastener retaining the rear door module (1).

Remove the module (1).

INSTALLATION PROCEDURE
1. Install the module (1).
2. Install the junction block into position. Install the fasteners.
3. Connect the electrical connector to the module (1).
4. Install the rear seat cushion.
5. Connect the negative battery cable.