Fluid - A/T: Service and Repair

Removal Procedure

^ Tools Required
- J 6125-1B
- J 23129





1. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
2. Place the drain pan under the transaxle oil pan.

Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.

3. Remove the oil pan bolts from only the front and the sides.
4. Loosen the rear oil pan bolts about 4 turns.
5. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
6. Inspect the fluid color.





7. Remove the remaining oil pan bolts.





8. Remove the oil pan.





9. Remove the oil pan gasket.





10. Remove the oil filter. Use a long screwdriver in order to pry the oil filter neck out of the seal.
11. Check the oil filter seal for damage or wear.
12. As needed, remove the seal using the J6125-1B and the J 23129.


Installation Procedure





1. Install a new seal, as needed. Before installing, coat the new seal with a small amount of J 36580 or petroleum jelly.
2. Install a new filter into the case.





3. Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.





4. Install the oil pan.





5. Install the oil pan bolts.

Notice: Refer to Fastener Notice in Service Precautions.

^ Tighten the bolts to 16 Nm (12 ft. lbs.).
6. Lower the vehicle.
7. Fill the transaxle to the proper level with DEXRON Al fluid or the equivalent.
8. Check the COLD fluid level reading for the initial fill. Do not overfill.
9. Inspect the oil pan gasket for leaks.