Transmission Temperature Sensor/Switch: Service and Repair

Removal Procedure





1. Remove the case side cover. Refer to Case Cover, A/T.
2. Disconnect the wiring harness assembly (224) from the electrical connector (35) in the case.





3. Disconnect the wiring harness assembly (224) from the following components:
^ The 1 - 2 shift solenoid (315)
^ The 2 - 3 shift solenoid (315)
^ The torque converter clutch solenoid (315)
^ The torque converter clutch PWM solenoid (325)
^ The wiring harness clip
4. Remove the wiring harness assembly with fluid temperature sensor.





5. Inspect the wiring harness assembly (224) for the following:
^ Cut or pinched wires
^ Cut wire insulation
^ Bent or broken electrical connectors

Installation Procedure





1. Install the wiring harness assembly with fluid temperature sensor.
2. Connect the wiring harness assembly (224) to the following components:
^ The 1 - 2 shift solenoid (315)
^ The 2 - 3 shift solenoid (315)
^ The torque converter clutch solenoid (315)
^ The torque converter clutch PWM solenoid (325)
^ The wiring harness clip





3. Connect the wiring harness assembly (224) to the electrical connector (35) in the case.
4. Install the case side cover. Refer to Case Cover, A/T.