Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the fuel injection sight shield.
3. Remove the MAP sensor screws.
4. Disconnect the MAP sensor electrical connector and vacuum hose from the sensor.
5. Remove the MAP sensor.

INSTALLATION PROCEDURE
1. Connect the electrical connector and vacuum hose to the MAP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Position the MAP sensor to the bracket and secure with the screws.
3. Reinstall the fuel injection sight shield.
4. Connect the negative battery cable.