Solar Sensor: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the instrument panel upper trim pad.
3. Disconnect the sunload temperature sensor (1) and the daytime running lamp light sensor (3) from the defroster grille.
4. Disconnect the electrical connector (2) to the sun load temperature sensor.
5. Remove the sunload sensor (1).

INSTALLATION PROCEDURE
1. Connect the electrical connector (2) to the sun load sensor.
2. Install the sun load temperature sensor (1) and the daytime running lamp light sensor (3) to the defroster grille.
3. Install the instrument panel upper trim pad.
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging System.