Knock Sensor: Service and Repair

REMOVAL PROCEDURE





CAUTION: Hot engine coolant may cause severe burns. Although the cooling system has been drained, coolant still remains In the engine water jacket. This coolant will drain with the removal of the knock sensor.

1. Turn OFF the Ignition.
2. Raise the vehicle. Refer to Vehicle Lifting in Service Precautions.
3. Remove the splash shield.
4. Drain the cooling system. Refer to Draining and Filling Cooling System in engine Cooling.




5. Remove the knock sensor heat shield mounting bolt located under the freeze plug (or block heater if equipped).
6. Disconnect the knock sensor wiring harness connector from the knock sensor.
7. Remove the knock sensor from the engine block.





INSTALLATION PROCEDURE

IMPORTANT: Do Not apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensors ability to detect detonation.

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the knock sensor into the engine block.

Tighten
Knock sensor to 19 N.m (14 lb ft).

2. Install the knock sensor heat shield mounting bolt located under the freeze plug (or block heater if equipped).
3. Connect the knock sensor wiring harness connector to the knock sensor.
4. Install the splash shield.
5. Lower the vehicle.
6. Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.