Electronic Brake Control Module: Service and Repair

REMOVAL PROCEDURE

NOTICE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.





1. Turn the ignition switch to the OFF position.
2. Remove red locking tab from connector lock tab (1).
3. Push down lock tab (1) and then move sliding connector cover (2) to the open position.
4. Disconnect the EBCM/EBTCM harness connector.
5. Brush off any dirt/debris that has accumulated on the assembly.





6. Remove the four EBCM/EBTCM to BPMV screws (1).
7. Separate the EBCM/EBTCM (2) from the BPMV (3) by gently pulling apart until separated.

IMPORTANT: Do not pry apart using a tool. Be careful not to damage BPMV surface.

IMPORTANT: Care must be taken not to damage the solenoid valves when the EBCM/EBTCM is removed from the BPMV.

INSTALLATION PROCEDURE





1. Clean the BPMV surface with alcohol using a clean rag.
2. Install the EBCM/EBTCM (2) to the BPMV (3).
3. Install the four screws (1) that attaches the EBCM/EBTCM (2) to BPMV (3).

NOTICE: Refer to Fastener Notice in Service Precautions.

^ Tighten the four screws to 5 Nm (44 inch lbs.).





4. Connect the EBCM/EBTCM harness connector.
5. Push down lock tab (1) and then move sliding connector cover (2) back in the home position to lock.
6. Insert red locking tab back in place.
7. Turn the ignition switch to the RUN position, do not start engine.
8. Perform the A Diagnostic System Check - ABS.