Generator Brace Replacement

REMOVAL PROCEDURE
1. Remove the generator rear brace nut (5).
2. Remove the generator rear brace bolt (3).
3. Remove the generator rear brace (4).

INSTALLATION PROCEDURE
1. Install the generator rear brace (4).
2. Finger start the generator rear brace bolt (3).
3. Finger start the generator rear brace nut (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Tighten the generator bolts in the order described. The following is a mandatory torque sequence:

Tighten
4.1. Tighten the generator rear brace bolt (3) to 50 N.m (37 lb ft).
4.2. Tighten the generator rear brace nut (5) to 50 N.m (37 lb ft).