Power Window Motor: Service and Repair

This article has been updated with Bulletin No: 01-08-64-011.

FRONT / REAR DOOR WINDOW REGULATOR MOTOR REPLACEMENT
1. Remove the door trim panel.
2. Position the water deflector to allow access to the power window motor to door mounting screws.
3. Disconnect the motor electrical connector.
4. Remove the motor-to-door mounting screws.
5. Position the motor assembly through the door access opening to allow removal of the motor-to-window regulator mounting screws.





6. Remove the motor and door mounting bracket from the window regulator.
7. Install a new power window motor and door mounting bracket to the window regulator.

TIGHTEN
Screws to 6 Nm (53 lb in).

8. Reposition the motor to the door and install the mounting screws.

TIGHTEN
Screws to 10 Nm (89 lb in).

9. Reconnect the motor electrical connector.
10. Reposition the water deflector to the door.

IMPORTANT: Discard the old door trim panel retainers and replace with the new retainers before installing the door trim.

11. Install the new trim panel retainers to the door trim panel.
12. Install the door trim panel.
13. Verify proper operation of the power window.