Wiper Gear Box: Service and Repair

REMOVAL PROCEDURE





TOOLS REQUIRED
J 39232 Wiper Transmission Separator.

1. Remove the wiper arms from the wiper transmission drive shafts.
2. Remove the air inlet grille panel from the vehicle.
3. Remove the connector from the wiper motor.
4. Remove the wiper transmission from wiper motor crank arm using the J 39232.




5. Remove three screws and the wiper drive system module from the vehicle.
6. Remove three grommets from the tube frame.




7. Remove two caps from the wiper transmission.
8. Remove four screws and the wiper transmission from the tube frame.
9. Remove the wiper motor and crank arm from the tube frame.

INSTALLATION PROCEDURE





TOOLS REQUIRED
J 39529 Wiper Transmission Installer.

1. Install the wiper motor and crank arm onto the tube frame.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the wiper transmission on the tube frame with four screws.

Tighten
Tighten the screws to 9 N.m (80 lb in).

3. Install two new caps onto the wiper transmission.




4. Install three grommets onto the tube frame.




5. Install the wiper drive system module on the vehicle with three screws.

Tighten
Tighten the screws to 10 N.m (88 lb in).




6. Install the wiper transmission on the wiper motor crank arm using the J 39529.
7. Install the connector onto the wiper motor.
8. Install the air inlet grille panel on the vehicle.
9. Install the wiper arms onto the wiper transmission drive shafts.
10. Operate the wipers and check for proper operation.