Operation CHARM: Car repair manuals for everyone.

P0405












Circuit Description
The PCM monitors the EGR valve pintle position input to ensure that the valve responds properly to commands from the PCM and to detect a fault if the pintle position sensor circuit is open or shorted. If the PCM detects an excessively low EGR Feedback signal voltage, DTC P0405 will set.

Conditions for Running the DTC
System voltage is greater than 10 volts.

Conditions for Setting the DTC
^ EGR Feedback is less than 0.14 volt at any time.
^ The condition is present for longer than 20 seconds.

Action Taken When the DTC Sets
^ The PCM will illuminate the MIL during the second consecutive trip in which the diagnostic test has been run and failed.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame and Fail Records data.

Conditions for Clearing the MIL/DTC
^ The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.
^ The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

Diagnostic Aids
^ Poor connection at PCM or EGR Valve.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness appears to be OK, connect digital multimeter and check circuit continuity while moving connectors and wiring harnesses related to the EGR valve. A change in the digital multimeter display will indicate the location of the malfunction.

Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table:
2. Verifies that the malfunction is present.
3. If DTC P0405 will only set under certain conditions, the malfunction may be intermittent; Go to Diagnostic Aids. If an intermittent wiring problem is not present, check for a poor connection at the PCM or the EGR valve.
18. This vehicle is equipped with a PCM which utilizes an Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is being replaced, the new PCM must be programmed.