Instrument Panel (IP) - Endcap Replacement - Right

REMOVAL PROCEDURE
1. Remove the fastener (2) on the bottom of the right side trim panel (1).
2. Pull outward on the trim panel (1) in order to remove the trim panel (1).

INSTALLATION PROCEDURE
1. Align the trim panel (1) to the IP.
2. Push inward in order to fasten the trim panel to the IP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the fastener (2) to the trim panel.

Tighten
Tighten the fastener to 1.9 N.m (17 lb in).