Seat Adjuster Mechanism Replacement - Power

REMOVAL PROCEDURE




1. Remove the seat.
2. Remove the inner adjuster attaching bolts (1).
3. Disconnect the cable ends (4) from the inner adjuster (2).

IMPORTANT: If a shipping bar connects the 2 adjusters, remove the adjusters at the same time.

4. Remove the inner adjuster (2).
5. Remove the seat belt from the inner adjuster.




6. Disconnect the wiring harness (3).
7. Remove the outer adjuster attaching bolts (1).
8. Disconnect the cables (4) from the outer adjuster (2).
9. Remove the motor support attaching nut.
10. Remove the motor assembly from the adjuster.

INSTALLATION PROCEDURE




1. Install the motor assembly to the adjuster.
2. Install the motor support attaching nut.
3. Connect the cables to the outer adjuster (2).

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Install the outer adjuster attaching bolts (1).

Tighten
Tighten the bolts to 24 N.m (18 lb ft).

5. Install the seat belt to the inner adjuster.




6. Connect the cables (4) to the inner adjuster (2).
7. Install the bolts (1) to the inner adjuster (2).

Tighten
Tighten the bolts to 24 N.m (18 lb ft).

8. Install the seat.