Seat Back Replacement - Rear

REMOVAL PROCEDURE
1. Remove the seat cushion
2. Remove the lap belt nuts.
3. Remove the lap belts.
4. On seat backs with pass-through, remove the
2 retainers in the rear compartment. The retainers are secured near the pass-through opening.
5. Lift the seat back (2) up. This will release the guide wires from the hooks (1,3) and the body slot.
6. Remove the seat back (2).

INSTALLATION PROCEDURE
1. Install the seat back (2).
2. Engage the guide wires into the hooks (1,3).
3. Install the lap belts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Install the lap belt nuts.

Tighten
Tighten the lap belt nuts to 35 N.m (26 lb ft).

5. Install the seat backs with pass-through.
6. Install the 2 retainers to the rear compartment in order to secure the armrest.
7. Install the seat cushion.