Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.




2. Rotate the throttle lever.




3. Disconnect the cruise control cable (1) from the bracket.
4. Disconnect the accelerator control cable (3) from the bracket (4).
5. Remove wiring harness clip from bracket (2).




6. Remove the two bolts from the bracket.

INSTALLATION PROCEDURE





NOTE:
^ Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.
^ Refer to Fastener Notice in Service Precautions.

1. Install the two brackets bolts.

Tighten
Tighten the bolts to 16 N.m (12 lb ft).




2. Install wing harness clip (2) to bracket.
3. Install the accelerator control cable (3) to the bracket.
4. Install the cruise control cable (1) to the bracket.





IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
6. Install the fuel injection sight shield.

Tighten
Tighten the bolt to 2 N.m (18 lb in).