Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL PROCEDURE




1. Remove the fuel injection sight shield.




2. Remove two bolts (1) from the MAP sensor (2).
3. Disconnect the MAP sensor electrical connector (3) from the MAP sensor (2).
4. Disconnect the MAP sensor vacuum hose (4) from the MAP sensor.
5. Remove the MAP sensor from the engine.

INSTALLATION PROCEDURE




1. Connect the electrical connector (3) and vacuum hose to the MAP sensor.
2. Connect the vacuum hose (4) to the MAP sensor (2).
3. Position the MAP sensor to the bracket and secure with the bolts (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolts to 3 N.m (27 lb in).




4. Install the fuel injection sight shield.