Glass Height (Rotational) Adjustment

1. Mark the up stop positions (2) at the full up position.
2. Lower the glass from the full up position in order to relieve pressure on the up stops.
3. Adjust the glass height adjusters (2), as necessary.




4. Inspect the glass height adjustment by completing the following steps:
4.1. Apply masking tape over the top edge of the glass.
4.2. With the glass at the full up position, make a pen mark on the tape along the molding (2).
4.3. Verify that The glass engagement is a minimum of 5.0 mm (0.20 in).
4.4. Verify that the swing clearance of the door glass is a minimum of 2.0 (0.08 in).
4.5. Verify that adequate power is available to the window motor so that system is in maximum compression.
5. Lower the glass.
6. Raise the glass.
7. Verify the measurements.
8. Repeat steps 1-3, as necessary.
9. Close the door with the window in the full up position.
Observe whether the glass rubs or is very close to rubbing the roof rail molding.