Wiper Motor Park Switch Replacement

REMOVAL PROCEDURE
1. Remove the wiper motor.
2. If the wiper motor cover is in the park position, operate the wiper motor as required to remove the pawl from the relay slot.
Remove three screws and the wiper motor cover.
3. Remove the screw and the park switch from the wiper motor.

INSTALLATION PROCEDURE
1. Install the park switch with the screw.
2. Operate the wiper motor back into the park position (pawl is in the relay slot).

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the wiper motor cover onto the wiper motor with three screws.

Tighten
Tighten three screws to 3 N.m (26 lb in).

4. Install the wiper motor onto the vehicle.