B0041
Diagnostic Chart 1 Of 2:
Diagnostic Chart 2 Of 2:
Schematics:
CIRCUIT DESCRIPTION
When you first turn ON the ignition, the inflatable restraint Sensing and Diagnostic Module (SDM) performs tests to diagnose critical malfunctions within itself. Then the SDM performs the following continuous diagnostic tests on the deployment loops:
^ Deployment loop voltage out of range test
^ Deployment loop resistance measurement test
If the voltage out of range test detects a short to voltage condition, the resistance measurement test for that deployment loop will not be performed.
CONDITIONS FOR RUNNING THE DTC
Deployment loop voltage out of range test:
^ Ignition 1 voltage is within the normal operating voltage range.
^ Driver side deployment loop is not shorted to voltage.
^ Driver side high terminal B1 of connector C2 is less than 2 volts.
Deployment loop resistance measurement test:
^ Ignition 1 voltage is within the normal operating voltage range.
^ Driver side deployment loop is not shorted to voltage.
^ Driver side deployment loop is not shorted to ground.
CONDITIONS FOR SETTING THE DTC
Deployment loop voltage out of range test - Driver side deployment loop resistance is at least 6 ohms for 300 milliseconds.
Deployment loop resistance measurement test - Driver side deployment loop resistance is more than 3.7 ohms for 300 milliseconds.
ACTION TAKEN WHEN THE DTC SETS
The SDM commands ON the AIR BAG warning lamp via Class 2 serial data.
CONDITIONS FOR CLEARING THE DTC
^ You can issue a CLEAR CODES command
^ A history DTC will clear once 255 malfunction free ignition cycles have occurred
DIAGNOSTIC AIDS
The following can cause an intermittent condition:
^ The inflatable restraint driver seat module yellow 2-way harness connector terminal A and terminal B.
^ The SDM wiring harness connector C2 terminal B1 and terminal B2.
^ The wire to terminal connections in the driver side high circuit.
^ The wire to terminal connections in the driver side low circuit.
^ Refer to Testing for Intermittent and Poor Connections in Diagrams.
TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. This step checks the inflatable restraint driver seat module yellow 2-way connector.
5. This step checks to see if there is a malfunctioning inflatable restraint driver seat module.
7. This step checks to see if there is an open or a high resistance in the driver side high circuit.
9. This step determines if there is an open or a high resistance in the driver side low circuit or if there is a malfunctioning SDM.